Inspection Checklist for the Power Cord and Power Plug - Canon Thailand

Contact the local Canon Service Centres if any of the following problems are found:

• There are burn marks on the power plug. It is possible that tracking phenomena have started. This is a dangerous condition.

• A power plug prong is deformed.

• The power supply goes off and on when the power cord is bent.

• There are cuts, cracks, or indentations on the power cord.

• A portion of the power cord becomes hot.

Examples that may cause electric shock or fire and are dangerous:

• Dust or debris has accumulated on the power supply outlet and power plug. 
  (Recommendation: Turn the power switch off, disconnect the power plug, and remove dust and debris with a dry cloth.)

• The connector on the device side is loose.
  (Recommendation: Push the connector firmly all the way in.)

• Stress is being applied to the power cord. 
  (Recommendation: Position the power cord so that it is not subjected to stress.)

• Disconnecting the plug by pulling on the power cord. 
  (Recommendation: Always disconnect the power plug by pulling on the plug rather than the cord.)

• Connecting or disconnecting the power plug with wet hands. 
  (Recommendation: Dry your hands completely with a towel, etc., before connecting or disconnecting the power plug.)

• The power plug is loose. 
  (Recommendation: Push the power plug firmly all the way in.)

• The power cord is tied in a bundle. 
  (Recommendation: Loosen the power cord.)

• The power cord protrudes into a walkway. 
  (Recommendation: Position the power cord so that it will not obstruct the walkway.)

• The power cord is in front of a heater. 
  (Recommendation: Position the power cord in a location that is not subjected to heat radiation.)

• The product or table tap is at a location near water access. 
  (Recommendation: Water is the enemy of electricity. Do not use electrical products at a location on which water may come.)

• An excessive number of cords are connected. It is possible that the rated capacity of the table tap has been exceeded. 
  (Recommendation: Do not connect an excessive number of cords.)